Tel: 02 9427 6755

Torus - CS Power

Rock Bottom Prices

LIMITED QUANTITY TO CLEAR AT REDUCED PRICES, FOR EXAMPLE

Remaining Model:
CS4AUSB/S (4 amp, 6 outlets) was $3499 now $1299
 
 (See also the AVR Series, nearly all gone)

 

Torus CS Series Power Conditioners provides a full-feature power conditioner, isolating and protecting your system. True isolation - using massive toroidal transformers. Torus CS series protects all connected equipment from the risk of severe power line surges using series-mode surge suppression.

 
Clean AC Power and Noise Filtration
Series Mode Surge Suppression
High Instantaneous Current Capability
Input Current Limiting
Surge Suppression that really works
 
 
 Torus CS Power provides very low source impedance to any connected devices. A low impedance power source allows a power amplifier to instantaneously deliver high amounts of current. A typical 200W audio power amplifier demands 10A RMS current from a 120V line but may demand up to 50A instantaneous peaks. The standard residential wall receptacle can't supply the 50A peaks. A 20A Torus Power Audio VideoPower Conditioner can deliver 400A peaks when the system demands it.
 
A combination of advanced engineering and precision manufacturing allows Torus Power Conditioners to achieve the highest levels of electrical isolation, operating as an electronic firewall separating your sensitive electronicequipment from electrical impurities carried on the common power grid, while maintaining total product performance, and preserving the integrity of audio and video signals.
 
Torus CS Power products use the finest, most sophisticated surge suppression technology available. Series Mode Surge Suppression does not shunt the spike to ground like MOV's do, therefore preventing ground contamination. Additionally, most MOV-based surge suppression units allow as much as 300V through to the protected components, easily enough to do substantial damage. Torus Power surge suppression has aclamping voltage onset of 2V above peak voltage. Torus Power is built to withstand 6000V, 3000A surges, with up to 1000 repeats.
 
Torus CS Power uses Plitron’s LoNo (Low Noise) transformer design technology that eliminates audible noise in the power transformer regardless of line conditions, DC offset and over-voltage. Torus Power products perform at theNC10 level measured on the standard NC (Noise Criterion curve) – which makes them suitable for use in very quiet environments such as professional recording and broadcast studios, as well as the most demanding consumer audio video systems.
 
Balanced input power (2 X 120V) provides additional noise cancellation as the two input phases are 180 degrees out of phase from each other. Additionally, the input current is drawn at one half the output current capacity.
 
Torus CS Power uses Plitron’s NBT (Narrow Band Technology) to attenuate differential and common-mode noise without external current limiting circuits or components. Torus Power provides noise filtering across a range from approximately 2kHz to over 1MHz – other regular transformer based products do not start operating until nearly 10kHz.
Print

Contact Len Wallis Audio

Address: 64 Burns Bay Road,
Lane Cove NSW 2066,
Australia
Telephone: (02) 9427 6755
Email: info@lenwallisaudio.com.au
http://lenwallisaudio.com